| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A flaw was found in SSSD. A local attacker can exploit this vulnerability by sending a specially crafted request to the autofs responder UNIX socket. Due to improper buffer offset calculation during request parsing, the service performs an out-of-bounds memory read. This flaw can cause the autofs responder process to crash, resulting in a denial of service (DoS). |
| A repository's external issue tracker regular expression containing alternating capture groups could produce invalid slice indexes when Gitea rendered issue references, causing a runtime panic that terminated the Gitea process. A user who can edit a repository's external issue tracker settings could make any later rendering of matching content, such as viewing a README, crash the instance for all users. |
| A flaw was found in sssd. A local attacker can cause a Denial of Service (DoS) by sending a crafted Pluggable Authentication Module (PAM) request containing a zero-length authentication token to the responder socket. Due to missing input validation, the service attempts to read beyond buffer boundaries when processing the token, causing the PAM responder to crash. |
| In the Linux kernel, the following vulnerability has been resolved:
ethtool: eeprom: add more safeties to EEPROM Netlink fallback
The Netlink fallback path for reading module EEPROM
(fallback_set_params()) validates that offset < eeprom_len,
but does not check that offset + length stays within eeprom_len.
The ioctl equivalent (ethtool_get_any_eeprom() in ioctl.c) has
always enforced both bounds:
if (eeprom.offset + eeprom.len > total_len)
return -EINVAL;
This could lead to surprises in both drivers and device FW.
Add the missing offset + length validation to fallback_set_params(),
mirroring the ioctl.
Similarly - ethtool core in general, and ethtool_get_any_eeprom()
in particular tries to zero-init all buffers passed to the drivers
to avoid any extra work of zeroing things out. eeprom_fallback()
uses a plain kmalloc(), change it to zalloc. |
| In the Linux kernel, the following vulnerability has been resolved:
tunnels: do not assume transport header in iptunnel_pmtud_check_icmp()
In some cases, iptunnel_pmtud_check_icmp() can be called while
skb transport header is not set.
This triggers an out-of-bound access, because
(typeof(skb->transport_header))~0U is 65535.
Access the icmp header based on IPv4 network header,
after making sure icmp->type is present in skb linear part.
Note that iptunnel_pmtud_check_icmpv6()) is fine. |
| Excelize is a Go language library for reading and writing Microsoft Excel spreadsheets. From 2.7.1 to 2.11.0, mergeCellsParser leaves the cached rectangle empty for an empty mergeCell ref and then passes that empty slice to cellInRange without a length check. GetCellValue reaches mergeCellsParser, which passes an empty rectangle derived from the mergeCell ref attribute into cellInRange. When a crafted worksheet contains an empty mergeCell ref and a non-streaming cell API reads the worksheet, cellInRange indexes four positions in an empty slice, allowing an attacker to panic on the first affected cell operation. No fixed version is available as of this review. |
| In NTFS-3G before 2026.7.7, a out-of-bounds read exists in ntfs_fix_file_name() in libntfs-3g/reparse.c that allows an attacker to read possibly confidential information in ntfs-3g process memory by crafting a malicious NTFS image. The out-of-bounds read is triggered by a readlink on a corrupted file. |
| Out of bounds read in Skia in Google Chrome prior to 155.0.8059.39 allowed a local attacker leveraging social engineering to potentially read memory via a crafted file. (Chromium security severity: Low) |
| As part of Cisco's ongoing commitment to proactive security and product quality, the Cisco NX-OS engineering team has conducted a comprehensive internal security review. This review resulted in a software hardening release that addresses multiple internally discovered vulnerabilities.
The vulnerabilities tracked by CVE-2026-76457 are related to out-of-bounds read issues that are grouped under the Common Weakness Enumeration (CWE) CWE-125. |
| Insufficient input validation leading to memory overread when the NetScaler is configured as a Gateway (VPN virtual server, ICA Proxy, CVPN, RDP Proxy) OR AAA virtual server |
| Out of bounds read in ANGLE in Google Chrome prior to 155.0.8059.39 allowed a remote attacker to read memory outside the sandbox via a crafted HTML page. (Chromium security severity: Medium) |
| ImageMagick is free and open-source software used for editing and manipulating digital images. Prior to 7.1.2-31, a client connected to the distributed pixel cache server can send crafted pixel data that triggers an integer-size calculation error and a heap buffer overwrite, crashing the server. This issue is fixed in version 7.1.2-31. |
| Out of bounds read in Printing in Google Chrome on on Windows prior to 155.0.8059.39 allowed a remote attacker who had compromised the renderer process and leveraged social engineering to read memory outside the sandbox via a crafted HTML page. (Chromium security severity: Medium) |
| libexpat before commit 13c5f63 contains a heap buffer over-read vulnerability in xmlparse.c. XML_ParseBuffer advances the parse buffer end with parser->m_bufferEnd += len using a caller-supplied length that is not validated against the allocated buffer size, so repeated XML_ParseBuffer calls move m_bufferEnd past the end of the heap allocation and subsequent parsing reads out of bounds. Reaching this path requires a parse buffer to already be present; otherwise XML_ParseBuffer returns XML_ERROR_NO_BUFFER. A buffer is present after a prior call to XML_GetBuffer, either directly (the common case) or indirectly through a prior XML_Parse call that allocates the buffer internally. The over-read discloses adjacent heap memory to the calling application, recovering heap pointers, libc function pointers, and code pointers sufficient to defeat ASLR and build further exploitation primitives. |
| In the Linux kernel, the following vulnerability has been resolved:
swiotlb: use the adjusted address for the highmem page lookup
swiotlb_bounce() reads the page frame number from the slot's recorded
orig_addr, then advances orig_addr by tlb_offset to reach the address
the caller asked about. The highmem branch mixes the two: the offset
within the page comes from the adjusted address, the page from the value
before it.
Once the adjustment crosses a page boundary the pair no longer describes
one location, and the whole copy lands one page below the intended one
for a positive tlb_offset, one above for a negative one. DMA_FROM_DEVICE
writes the device data over the wrong page and leaves the intended one
stale, DMA_TO_DEVICE feeds the device from a page the mapping may not
cover. Partial syncs through dma_sync_single_range_for_*() are what make
tlb_offset non-zero.
The branch test is picked the same way, so a slot recorded in lowmem can
be adjusted into highmem and the lowmem path then hands a highmem
address to phys_to_virt().
Take both from orig_addr once it is final and keep pfn in the branch
that uses it. PhysHighMem() asks the question straight from the address,
as dma-debug already does. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: libipw: reject too-short beacon and probe responses
libipw_process_probe_response() and the libipw_network_init() call it
makes assume the frame contains the full 36-byte beacon and probe
response prefix, but the ipw2100 and ipw2200 receive paths only
establish that a management frame carries the generic 24-byte
three-address header.
libipw_network_init() then computes the information element length as
stats->len - sizeof(*beacon)
stats->len is a u16 and sizeof() has type size_t, so the subtraction is
evaluated as size_t and wraps instead of going negative. Truncating
that to the u16 length parameter of libipw_parse_info_param() yields
65524 for a 24-byte beacon, and the parser then walks the receive
buffer as if it held almost 64 KiB of information elements, reading
past the allocation.
Reject the frame before any fixed field is touched.
Found by an AI-assisted review of length arithmetic in management frame
parsers. Verified with a KUnit case under Generic KASAN on arm64 under
QEMU; I do not have the hardware, so it is not tested on a real device. |
| GNU Aspell contains an out-of-bounds read vulnerability in ReadOnlyDict::load() in readonly_ws.cpp. When loading a binary .rws dictionary file, it uses offset fields from the file header as byte indices into a heap buffer without validating their bounds. An attacker can trigger this by convincing a user to run aspell with a crafted dictionary file supplied through --master, --dict-dir, or configuration options, leading to heap memory disclosure or a denial of service via application crash.
This issue was fixed in commit 941953b25031bc9104e83f58e138a664b8dedc3f which will be released in version 0.60.8.3. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix potential OOB read in smb3_enum_snapshots()
If snapshot_array_size is smaller than GMT_TOKEN_SIZE,
smb3_enum_snapshots() sets ret_data_len to
sizeof(struct smb_snapshot_array) without verifying the actual length
of the server's reply.
Because SMB2_ioctl() places no lower bound on the server-supplied
OutputCount and allocates retbuf to exactly that length, a short reply
results in ret_data_len exceeding the size of retbuf. The subsequent
copy_to_user() then reads past the end of retbuf, leaking adjacent slab
memory to userspace. The subsequent clamp check is ineffective as it
only reduces ret_data_len.
Fix this by rejecting replies shorter than
sizeof(struct smb_snapshot_array) with -EIO. Note that the bound is set
to the 12-byte struct size rather than the 16-byte
MIN_SNAPSHOT_ARRAY_SIZE defined in MS-SMB2 3.3.5.15.1, because 12 bytes
is exactly what copy_to_user() attempts to read. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: wilc1000: fix out-of-bounds read in P2P public action frames
wilc_wfi_p2p_rx() and mgmt_tx() start parsing a frame once
ieee80211_is_public_action() returns true. That helper only verifies the
frame is long enough for the action category field, that is
offsetofend(struct ieee80211_mgmt, u.action.category), 25 bytes. Both
functions then read the P2P public action header up to oui_subtype at
offset 30 and pass "size - ie_offset" to cfg80211_find_vendor_ie(), where
ie_offset is offsetof(struct ieee80211_mgmt, u) + sizeof(*d), i.e. 32.
A public action frame of 25 to 31 bytes passes the check but is shorter
than that 32 byte header, so oui_subtype can be read out of bounds, and
because the length is unsigned, "size - ie_offset" underflows to a value
close to 4 GiB. cfg80211_find_vendor_ie() takes an unsigned int length,
so even the size_t subtraction in mgmt_tx() is truncated to the same
value. It then walks far past the buffer searching for a vendor element
until it reaches unmapped memory.
In the receive path the frame arrives over the air and needs no
association, so a nearby unauthenticated device can crash the host while
it is in P2P listen. Reject frames shorter than the P2P public action
header in both paths before dereferencing it. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix OOB struct field reads in move_smb2_ea_to_cifs()
In move_smb2_ea_to_cifs(), the while (src_size > 0) loop condition is
insufficient. It allows iteration to continue even if the remaining
src_size is too small to contain a complete smb2_ea_info structure.
Consequently, reads of ea_name_length and ea_value_length can occur
out-of-bounds.
Fix this by ensuring src_size >= sizeof(*src) before attempting to read
any structure fields. Additionally, reject any next_entry_offset that is
smaller than sizeof(*src) or that would advance the pointer beyond the
available buffer.
Note that for calls where the server returns a malformed EA list, the
error returned to userspace changes from -ENODATA (getxattr) or
-ERANGE (listxattr) to -EIO. This correctly signals a server protocol
error rather than misleadingly indicating "attribute not present" or
"output buffer too small". |
