| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
riscv: lib: Fix ZBB strnlen reading past count boundary
The ZBB-optimized strnlen loop loads one word ahead before checking the
aligned boundary:
REG_L t1, SZREG(t0) // load next word
addi t0, t0, SZREG // advance
orc.b t1, t1
bgeu t0, t4, 4f // boundary check AFTER load
where t4 = (s + count) & -SZREG. When s is aligned and count is a
multiple of SZREG, t4 equals s + count and the loop loads a full word
starting at exactly s + count. If s + count falls on a page boundary
with the next page unmapped, this faults.
Fix by computing the aligned boundary from the last valid byte
(s + count - 1) instead of s + count. This makes the loop stop at the
word containing the last valid byte rather than potentially loading the
word after it. The count == 0 case is already handled by the beqz
early exit.
Also add a pre-loop guard (bgeu t0, t4) for the case where all valid
bytes fit within the first word. With the adjusted boundary, t4 can
equal t0, and entering the loop with stale register state from the
first-word processing would produce incorrect results.
The final minu clamp ensures the result is still correct when the last
loaded word extends past s + count - 1 within the same aligned word. |
| darknet subscripts its layer array with an index taken from a configuration file without checking it against the array's length. The array is allocated in src-lib/darknet_network.cpp as xcalloc(net.n, sizeof(Darknet::Layer)), sized to exactly the number of layer sections the file declares. The shortcut, scale_channels and sam sections supply that index through their from field and the route section through its layers field, and parse_shortcut_section in src-lib/darknet_cfg.cpp reads net.layers[index].outputs with no bounds check, which reads past the allocation. The dispatch loop in create_network then reuses the same index to assign net.layers[l.index].use_bin_output and net.layers[l.index].keep_delta_gpu, writing past the allocation at an offset the file controls, with a fixed one-byte value. Parsing a crafted configuration file is sufficient: the parse runs before any weights file is opened and needs no non-default option, so the result is a reliable crash and a write whose location, though not its value, is chosen by whoever supplied the file. |
| An out-of-bounds read was found in the DHCPv4 packet capture code of wicked. ni_capture_inspect_udp_header() in src/capture.c reports the IP total length as the payload length instead of the length of the remaining UDP payload. Consequently, the DHCP option walker in the DHCPv4 client (wickedd-dhcp4) reads up to ihl + 8 bytes — at most 68 bytes — past the end of the 1500-byte packet receive buffer. An unauthenticated attacker on the same network who sends a crafted DHCP/UDP packet can make the client parse adjacent heap memory as DHCP options, so that heap contents such as allocator metadata or pointer values can be interpreted into lease fields. The over-read is bounded to 68 bytes; no memory write, no attacker control over the adjacent bytes and no remote exfiltration primitive has been demonstrated. This issue affects wicked up to and including version 0.6.80. |
| Out of bounds read in Tint in Google Chrome on on Android prior to 152.0.7977.65 allowed a remote attacker to potentially read memory inside the sandbox via a crafted HTML page. (Chromium security severity: Low) |
| A vulnerability has been found in Systerel S2OPC up to 1.7.3. Impacted is the function SOPC_NodeMgtHelperInternal_AddVariableNodeAttributes of the file src/ClientServer/address_space/internal/sopc_node_mgt_helper_internal.c of the component AddNodes Service. The manipulation of the argument UserAccessLevel leads to out-of-bounds read. It is possible to initiate the attack remotely. A high degree of complexity is needed for the attack. The exploitability is considered difficult. The exploit has been disclosed to the public and may be used. The identifier of the patch is aafbd37d381b618312ebdf5ddf57027f62c14fdd. It is suggested to install a patch to address this issue. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a local attacker to execute arbitrary code due to an out-of-bounds read. |
| Out-of-bounds read in Remote Desktop Client allows an unauthorized attacker to disclose information over a network. |
| In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8723bs: fix OOB read in WMM_param_handler()
WMM_param_handler() copies a fixed-size WMM parameter element out of a
received information element without checking that the element is long
enough, causing an out-of-bounds read for a short WMM IE.
The handler reads sizeof(struct WMM_para_element) (18) bytes at
pIE->data + 6, so it requires pIE->length to be at least 24
(WLAN_WMM_LEN), but it never validates the length. Two of its three
callers reach it after matching only the WMM OUI: OnAssocRsp() in
rtw_mlme_ext.c matches a 6-byte OUI, and join_cmd_hdl() matches a
4-byte OUI, before calling the handler. A vendor-specific IE carrying
the WMM OUI but a length between 6 and 23, placed in an association
response or in the IE blob handed to join_cmd_hdl(), passes the OUI
check and then makes the memcmp() and memcpy() at pIE->data + 6 read
past the end of the element. OnAssocRsp() parses a frame received from
the AP, so this is reachable from a remote peer.
The remaining caller in rtw_wlan_util.c already guards the handler with
"pIE->length == WLAN_WMM_LEN". Move the equivalent check into the
handler itself so every caller is covered; the sibling IE handlers in
the same parsing loop (HT_caps_handler(), HT_info_handler(),
ERP_IE_handler()) likewise bound their accesses by pIE->length. |
| In the Linux kernel, the following vulnerability has been resolved:
tls: handle data disappearing from under the TLS ULP
TLS expects that it owns the receive queue of the TCP socket.
This cannot be guaranteed in case the reader of the TCP socket
entered before the TLS ULP was installed, or uses some non-standard
read API (eg. zerocopy ones). Replace the WARN_ON() and a buggy
early exit (which leaves anchor pointing to a freed skb) with real
error handling. Wipe the parsing state and tell the reader to retry.
We already reload the anchor every time we (re)acquire the socket lock,
so the only condition we need to avoid is an out of bounds read
(not having enough bytes in the socket for previously parsed record len).
If some data was read from under TLS but there's enough in the queue
we'll reload and decrypt what is most likely not a valid TLS record.
Leading to some undefined behavior from TLS perspective (corrupting
a stream? missing an alert? missing an attack?) but no kernel crash
should take place. |
| In the Linux kernel, the following vulnerability has been resolved:
net: ethernet: ti: am65-cpsw-nuss: Fix port_id extraction from SRC TAG
On the packet reception path, the ID of the MAC Port on which the packet
was received, is embedded in the RX DMA Descriptor's metadata. The ID is
extracted using the helper function cppi5_desc_get_tags_ids() which fills
in the 16-bit Source Tag into the 'port_id' variable. However, it is only
the lower 8-bits of the 16-bit Source Tag that represent the MAC Port ID,
while the upper 8-bits are Hardware-Reserved and carry an arbitrary value.
With the existing logic, sporadic kernel crash is observed due to the
subsequent driver code accessing out-of-bound memory because of an invalid
port_id.
Hence, fix the port_id extraction logic to use only the lower 8-bits of the
Source Tag as the MAC Port ID. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: iforce - validate input packet lengths
iforce_process_packet() reads fixed fields from joystick, wheel and
status packets without first checking their lengths. In particular, the
shared hats-and-buttons helper unconditionally reads data[6]. The status
tail is a sequence of 16-bit effect addresses, but an incomplete final
address is also consumed. A successful zero-length USB URB additionally
reads the packet ID before the common parser is called.
Reject the zero-length USB transfer, require the seven-byte joystick and
wheel prefixes and the two-byte status prefix, and consume only complete
status-tail addresses. |
| DNG SDK versions 1.7.1 2536 and earlier are affected by an out-of-bounds read vulnerability that could lead to disclosure of sensitive memory. An attacker could leverage this vulnerability to disclose sensitive information. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| Out of bounds read in ANGLE in Google Chrome on on Windows prior to 152.0.7977.65 allowed a remote attacker to potentially execute arbitrary code outside the sandbox via a crafted HTML page. (Chromium security severity: High) |
| Out of bounds read in ANGLE in Google Chrome on on Windows prior to 152.0.7977.65 allowed a remote attacker to potentially execute arbitrary code outside the sandbox via a crafted HTML page. (Chromium security severity: Medium) |
| iccDEV provides a set of libraries and tools for working with ICC color management profiles. Versions prior to 2.3.2.1 have a `CIccEmbedIO::Read8()` size_t underflow. The issue arises due to an embedded-profile read defect when parsing ICC profiles containing `icSigEmbeddedV5ProfileTag` data with `icSigEmbeddedProfileType` payloads. Version 2.3.2.1 patches the issue. No known workarounds are available. |
| GNU coreutils uniq is vulnerable to an out‑of‑bounds read due to incorrect handling of multibyte input when the -w (--check-chars) option is used. The find_field() function miscalculates the byte length of characters by repeatedly processing a fixed pointer instead of advancing through the input, resulting in an inflated length value.
This incorrect length is later used in a memcmp operation, causing reads beyond the allocated buffer when processing crafted multibyte input.
When running GNU coreutils uniq with attacker-provided arguments, this behavior leads to a crash and potential adjacent heap memory exposure.
This issue has been fixed in the commit d64e35a8a4c0e4608321433e0d84d917e4e36371. |
| An out-of-bounds read/write vulnerability in the MessageParser::parseECSSTCHeader component of SpaceDot AcubeSAT OBC software commit eaf90ec allows attackers to cause a Denial of Service (DoS) via supplying a crafted CAN message. |
| IBM PowerVM Hypervisor FW1120.00, FW1110.00 through FW1110.30, FW1060.00 through FW1060.80, and FW950.00 through FW950.H2 is affected by a vulnerability in partition firmware during network boot. An unauthenticated attacker with access to the same network as a partition undergoing iSCSI SAN network boot can prevent that partition from completing its boot sequence. Other partitions and the managed system are not affected. Only partitions actively performing an iSCSI SAN network boot are affected, resulting in an availability impact. |
| OpenEXR is the reference implementation and specification for the EXR image format, widely used in the motion picture industry. From version 3.4.0 through 3.4.12, the HTJ2K decoder parses a header-length field (PLEN) from a chunk's compressed data but never checks that this value fits within the available buffer before using it. When decoding, it advances the codestream pointer by the attacker-supplied header size and passes the resulting offset and remaining length to the OpenJPH memory-input path, so a crafted value pushes the pointer past the end of the buffer and causes an out-of-bounds read. Because this field comes straight from attacker-controlled EXR chunk data, the flaw is reachable during normal decoding of an untrusted file. This issue is fixed in version 3.4.13. |
| The Zephyr ext2 filesystem driver validates the on-disk block bitmap in ext2_init_fs() (subsys/fs/ext2/ext2_impl.c) by passing fs_blocks = s_blocks_count - s_first_data_block to ext2_bitmap_count_set(). That helper (subsys/fs/ext2/ext2_bitmap.c) treats its argument as a number of bits and reads one bitmap byte per eight bits, but the bitmap buffer (BGROUP_BLOCK_BITMAP) is a single fetched block of only fs->block_size bytes (capacity fs->block_size * 8 bits). s_blocks_count and s_first_data_block are taken verbatim from the superblock and were never bounded against this single-group capacity; ext2_verify_disk_superblock() checks the magic, revision, and block-size shift but not the block count.
A crafted ext2 image with an oversized s_blocks_count (up to ~4 billion, against a maximum 4096-byte block / 32768-bit bitmap) makes ext2_bitmap_count_set() scan roughly 512 MB of memory past the bitmap block — a large out-of-bounds read of the static block slab and adjacent memory.
The defect is reached during mount: ext2_init_fs() is invoked from ext2_mount() (subsys/fs/ext2/ext2_ops.c), the registered .mount operation. Any path that mounts an attacker-supplied ext2 image (removable media, a disk/flash partition, or a downloaded image) triggers it. The kernel-privileged parser operates on attacker-controlled data, so the bug is exploitable wherever untrusted ext2 media can be mounted.
Impact is an out-of-bounds read only: the resulting bit count is compared internally and the mount is rejected, so no attacker-controlled bytes are returned (not a useful information leak). The ~512 MB over-read will almost certainly cross an unmapped or MPU-protected boundary and fault, crashing the system — a denial of service triggered by mounting a single malformed image. The fix rejects any image whose fs_blocks exceeds fs->block_size * 8 before the scan. |
