| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: wilc1000: fix out-of-bounds read in P2P public action frames
wilc_wfi_p2p_rx() and mgmt_tx() start parsing a frame once
ieee80211_is_public_action() returns true. That helper only verifies the
frame is long enough for the action category field, that is
offsetofend(struct ieee80211_mgmt, u.action.category), 25 bytes. Both
functions then read the P2P public action header up to oui_subtype at
offset 30 and pass "size - ie_offset" to cfg80211_find_vendor_ie(), where
ie_offset is offsetof(struct ieee80211_mgmt, u) + sizeof(*d), i.e. 32.
A public action frame of 25 to 31 bytes passes the check but is shorter
than that 32 byte header, so oui_subtype can be read out of bounds, and
because the length is unsigned, "size - ie_offset" underflows to a value
close to 4 GiB. cfg80211_find_vendor_ie() takes an unsigned int length,
so even the size_t subtraction in mgmt_tx() is truncated to the same
value. It then walks far past the buffer searching for a vendor element
until it reaches unmapped memory.
In the receive path the frame arrives over the air and needs no
association, so a nearby unauthenticated device can crash the host while
it is in P2P listen. Reject frames shorter than the P2P public action
header in both paths before dereferencing it. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix OOB struct field reads in move_smb2_ea_to_cifs()
In move_smb2_ea_to_cifs(), the while (src_size > 0) loop condition is
insufficient. It allows iteration to continue even if the remaining
src_size is too small to contain a complete smb2_ea_info structure.
Consequently, reads of ea_name_length and ea_value_length can occur
out-of-bounds.
Fix this by ensuring src_size >= sizeof(*src) before attempting to read
any structure fields. Additionally, reject any next_entry_offset that is
smaller than sizeof(*src) or that would advance the pointer beyond the
available buffer.
Note that for calls where the server returns a malformed EA list, the
error returned to userspace changes from -ENODATA (getxattr) or
-ERANGE (listxattr) to -EIO. This correctly signals a server protocol
error rather than misleadingly indicating "attribute not present" or
"output buffer too small". |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix server->total_read for compound encrypted PDUs
In receive_encrypted_standard(), server->total_read is left at the
full decrypted frame size when walking sub-PDUs of a compound encrypted
frame. As a result, cifs_handle_standard() passes this full size
to smb2_check_message(), causing the PDU length guards to incorrectly
validate the entire compound frame instead of the current sub-PDU.
This allows truncated non-last sub-PDUs to bypass length validation,
leading to out-of-bounds reads in smb2_get_data_area_len().
Fix this by setting server->total_read to the true length of the
current sub-PDU: next_cmd for non-last sub-PDUs, and the remaining
pdu_length for the last one. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix reparse buffer bounds in cifs_query_reparse_point()
In cifs_query_reparse_point(), the start >= end check before casting to
struct reparse_data_buffer * only ensures the start pointer is within the
response. It fails to verify that there is enough space remaining for the
fixed 8-byte header of the structure.
If a server provides a DataOffset that leaves less than 8 bytes remaining,
the check passes, but subsequent reads of ReparseTag and ReparseDataLength
will occur out-of-bounds.
Fix this by ensuring the remaining space is at least the size of the
reparse_data_buffer structure before accessing its fields. |
| NVIDIA TensorRT contains a vulnerability where an attacker can cause an out of bounds read. A successful exploit of this vulnerability may lead to denial of service. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btmtksdio, btmtkuart: validate WMT event length before struct access
btmtksdio.c and btmtkuart.c cast a received WMT event straight to
struct btmtk_hci_wmt_evt and read its op/flag fields without checking
the event is long enough to contain them, unlike btmtk.c. The
FUNC_CTRL case then further casts to struct btmtk_hci_wmt_evt_funcc
and reads its 2-byte status field, again without a length check.
Firmware that sends a short or malformed WMT event makes both drivers
read past the end of the received SKB.
Mirror btmtk.c: validate the base WMT header with skb_pull_data()
before touching any of its fields, and when a FUNC_CTRL event turns
out to be the short, header-only form (a plain enable/disable ack
with no status word), decode the result from the header's own flag
byte instead (0 = success, otherwise failure).
Verified setup on MT7920, MT7921, MT7922 and MT7925: no regression. |
| A flaw was found in GIMP’s X cursor (XMC) thumbnail loader. When GIMP generates a thumbnail for a crafted XMC file, it allocates a pixel buffer using a width * height size computed in 32-bit signed arithmetic. If that product overflows, the allocation is smaller than the true image extent. A subsequent GEGL buffer read uses the unwrapped dimensions and performs an out-of-bounds read on the heap (CWE-125), after integer overflow in the size calculation (CWE-190). This can crash GIMP or corrupt process memory. |
| On affected Arista access points configured with VXLAN tunnelling and L2-proxy (a specific configuration unique to the VESPA use-case), a wireless client associated to the tunnelled SSID can send a crafted packet, causing the access point to reveal memory contents in network traffic. No write primitive or remote code execution is possible. |
| A flaw was found in sssd. This vulnerability allows a local user to cause a Denial of Service (DoS) by submitting a specially crafted passkey authentication token that lacks null terminators. The authentication service reads past the end of the provided memory buffer, causing the process to crash and disrupting authentication services. |
| A heap-based buffer over-read in H5Z__filter_scaleoffset() in src/H5Zscaleoffset.c in HDF5 through 2.2.0 lets an attacker cause a denial of service (application crash) with a crafted HDF5 file. When the stored minimum bits equal the full precision of the datatype, the decoder copies d_nelmts * size bytes from the compressed chunk without checking that the chunk holds that many bytes. Both values come from attacker-controlled scale-offset filter parameters in the dataset's filter pipeline message. |
| A flaw was found in SSSD. A local attacker can exploit this issue by sending a specially crafted request with an invalid packet length to the autofs responder UNIX socket. This causes an integer underflow and an out-of-bounds memory read, which can crash the responder process and result in a denial of service (DoS). |
| A flaw was found in SSSD. A local attacker with access to the Name Service Switch (NSS) responder UNIX socket can trigger an integer underflow by sending a specially crafted request with an undersized packet header. This issue causes an out-of-bounds memory read during packet parsing, crashing the responder process and resulting in a Denial of Service (DoS). |
| In the Linux kernel, the following vulnerability has been resolved:
clk: scpi: bound-check DVFS index in scpi_dvfs_recalc_rate
dvfs_get_idx() may return an out-of-range index if the SCP firmware is
buggy or returns a stale value. Only negative indexes were rejected, so a
large index walked past info->opps and could treat garbage as a clock rate
(KASAN OOB / wrong frequency to consumers). The missing upper bound dates
back to the original SCPI clock driver.
Treat indexes >= opp count as invalid and return 0, same as idx < 0. |
| In the Linux kernel, the following vulnerability has been resolved:
xfrm: iptfs: fix stack OOB read in iptfs_skb_reset_frag_walk()
iptfs_skb_reset_frag_walk() advances to the fragment containing @offset
with an unbounded loop:
while (offset >= walk->past + walk->frags[walk->fragi].len)
walk->past += walk->frags[walk->fragi++].len;
walk->fragi is advanced and walk->frags[walk->fragi] is dereferenced
without ever checking fragi against walk->nr_frags. When the requested
offset is at or beyond the total length spanned by the walk's fragments,
fragi runs past nr_frags and off the end of the fixed-size on-stack
frags[MAX_SKB_FRAGS + 1] array, reading out-of-bounds stack memory.
The two callers behave differently: iptfs_skb_add_frags() already guards
against this with
if (!walk->nr_frags ||
offset >= walk->total + walk->initial_offset)
return len;
but iptfs_skb_can_add_frags() has no such guard and calls
iptfs_skb_reset_frag_walk() unconditionally, so it performs the
out-of-range walk. Its own "fragi < walk->nr_frags" bound check runs only
afterwards, too late to prevent the read.
This is reachable from the receive path: a crafted IP-TFS (AGGFRAG)
payload delivered to an IPTFS SA drives iptfs_reassem_cont() ->
iptfs_skb_can_add_frags() with an offset past the fragment total, e.g.:
BUG: KASAN: stack-out-of-bounds in iptfs_skb_reset_frag_walk+0x235/0x250
Read of size 4 at addr ffff888008ad7210 by task repro/345
iptfs_skb_reset_frag_walk+0x235/0x250 net/xfrm/xfrm_iptfs.c:392
iptfs_skb_can_add_frags+0x155/0x310 net/xfrm/xfrm_iptfs.c:420
iptfs_reassem_cont+0xcf8/0x1140 net/xfrm/xfrm_iptfs.c:902
iptfs_input_ordered+0x552/0x670 net/xfrm/xfrm_iptfs.c:1280
iptfs_input+0x3d6/0xde0 net/xfrm/xfrm_iptfs.c:1741
xfrm_input+0x282f/0x6140 net/xfrm/xfrm_input.c:700
xfrm4_esp_rcv+0x93/0x120 net/ipv4/xfrm4_protocol.c:104
ip_rcv+0x278/0x2d0 net/ipv4/ip_input.c:612
Give iptfs_skb_can_add_frags() the same up-front guard that
iptfs_skb_add_frags() already has, so the walk is never entered with an
out-of-range offset. When it triggers, the caller falls back to the
existing linearize-and-copy path, which is safe. |
| The H5Z__nbit_decompress_one_byte, H5Z__nbit_decompress_one_nooptype, and H5Z__nbit_decompress_one_atomic functions in H5Znbit.c in HDF5
prior to 2.3.0 advance a read index into the compressed chunk buffer without bounding it against the buffer's actual size. This allows attackers to cause an out-of-bounds heap read, and in constrained cases disclosure of adjacent heap memory into decompressed dataset values, via a crafted HDF5 file whose N-Bit filter parameters describe more decompressed data than the stored compressed chunk actually contains, triggered via H5Dread, e.g. by the h5ls or h5repack tools. |
| H5Z__filter_fletcher32 in H5Zfletcher32.c in HDF5 prior to 2.3.0 computes the data length to checksum by subtracting the 4-byte trailing checksum size from the input buffer size without checking that the buffer is at least 4 bytes, allowing a size_t underflow. This allows attackers to cause a denial of service (massively out-of-bounds read and application crash in H5_checksum_fletcher32) via a crafted HDF5 file with a Fletcher32-filtered chunk smaller than 4 bytes, triggered via H5Dread, e.g. by the h5ls or h5dump tools. |
| Vim is an open source, command line text editor. From 9.2.0469 until 9.2.0843, popup_mark_opacity_zindex() in src/popupwin.c can use a negative w_winrow for a text-property-anchored popup with clipwindow and opacity, indexing before the screen array instead of accounting for w_popup_topoff and causing an out-of-bounds read and conditional write. This issue is fixed in version 9.2.0843. |
| tftp-hpa 5.4 before 6.0 contains an out-of-bounds read vulnerability in rewrite_string() in tftpd/remap.c that walks heap memory during jump label searches. Unauthenticated remote attackers can send read or write requests whose filename matches a remap jump rule to crash the forked in.tftpd request handler. |
| libmikmod before 3.3.14 contains a heap out-of-bounds read vulnerability in the Impulse Tracker loader load_it.c that allows attackers to read adjacent heap memory via oversized patterns. Attackers can supply a crafted IT module with more than 200 pattern rows, causing IT_ConvertTrack() to read past the itpat buffer and crash applications. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mwifiex: bound the pairwise-cipher OUI walk to the IE length
mwifiex_search_oui_in_ie() reads a pairwise-cipher (PTK) count from a
beacon/probe-response RSN or WPA information element and then walks that
many 4-byte OUIs, comparing each with memcmp(). The count comes straight
from the (attacker-supplied) IE and is never checked against the
element's own length, and the callers admit the element on element_id
alone (has_ieee_hdr() / has_vendor_hdr(), no length check). A crafted
RSN/WPA IE with a large pairwise count therefore makes the walk read up
to 255 * 4 bytes past the element -- an out-of-bounds read of the
kmemdup()'d beacon buffer, reachable from any AP whose beacon/probe
response is processed during scan-result parsing.
Pass the number of IE bytes available at the OUI list and bound the walk
to the element. Keep the length signed and reject a negative value
before any unsigned arithmetic, so a small or zero IE length cannot
underflow to a large size_t and defeat the bound.
Found by 0sec automated security-research tooling (https://0sec.ai). |
